• 1 switching circuit with 12 A The switching circuit is capable of switching an output of 12 A /250 V AC. • Minus activation For the new generation of controllers with minus outputs, the A3 activation is activatable with a minus.
• AUTO-OFF-ON with feedback The switching circuit can switch to automatic or manual mode. In automatic mode the contact with feedback is closed, therefore a logic 1 results on the controller. Multiple feedbacks can be connected in series.
• DIN 45 mm housing The standardised housing enables the KBD-1 to be installed by means of a 45 mm cut-out behind the covering, it only requires a width of 17.5 mm for this. It only requires a width of 17.5 mm.
Input side
Rated voltage Un A1 - A2 24 V AC/DC
Power consumption 480 mW
Tolerance -15%; +10%
Output side
Switching voltage 250 V AC / 24 V DC
Switching current / Contact material 12 A / AC1 / AgNi
Max. peak current 20 A / <3s
Switching capacity 3000 VA / AC1, 288 mW
Min. DC switching capacity 300 mW, 5 V, 10 mA
Switch for feedback
Max. switching capacity 100 mA / 30 V
General data
Mechanical life 3 x 107
Electrical life at 12 A 0.7 x 105
Ambient temperature -20°C … +55°C
Storage temperature -30°C … +70°C
Test voltage Coil / Contact 2.5 kV
Mounting position Any
Fixing DIN rail EN 50022-35
Protection class of front IP 40
Voltage limitation class III
Degree of contamination 2
Connection cross section 2.5 mm2
Weight 78 g
Standards EN 61810-1, EN 618-10-1 + 2
Device Order-No.
Coupling module 1 changeover contact, minus activation, AUTO-OFF-ON with feedback KBD-1/M
Connecting bridge 8-pin AK-17-8
• 1 switching circuit with 12 A The switching circuit is capable of switching an output of 12 A /250 V AC. • Minus activation For the new generation of controllers with minus outputs, the A3 activation is activatable with a minus.
• AUTO-OFF-ON with feedback The switching circuit can switch to automatic or manual mode. In automatic mode the contact with feedback is closed, therefore a logic 1 results on the controller. Multiple feedbacks can be connected in series.
• DIN 45 mm housing The standardised housing enables the KBD-1 to be installed by means of a 45 mm cut-out behind the covering, it only requires a width of 17.5 mm for this. It only requires a width of 17.5 mm.
