Sleeve sensor with temperature measuring transducer (cable temperature measuring transducer) THERMASGARD® HFTM-I LCD

€166.55
Tax included

Calibratable THERMASGARD® HFTM temperature measuring transducer with sleeve sensor with eight switchable measuring ranges, continuous output, housing made of impact resistant plastic with quick-release screws, optionally with/without display, with cable gland or M12 connector according to DIN EN 61076-2-101.

The temperature transmitter with remote sensor serves to detect temperatures in liquid and gaseous media, e.g. if installed in a thermowell or as a duct sensor.

THERMASGARD®
Output model
Output
Display
Quantity

Power consumption

< 1,0 VA/ 24 V DC

< 2,2 VA/ 24 V AC

Voltage supply

15...36 V DC

depending on working resistance, residual ripple stabilised ± 0.3 V

Deviation of humidity

typically ± 0.2 K at +25 °C

Working resistance

Ra (ohm) = (Ub -14 V)/ 0.02 A for I variant

Temperature deviation

typically ± 0.2 K at +25 °C

Sensor

Pt1000, DIN EN 60751, class B

Connection type

2- or 3-wire connection

Ambient temperature

Measuring transducer –30...+70 °C

Insulating resistance

100 MΩ,

at +20 °C (500V DC)

Electrical connection

0.14 - 1.5 mm²

via terminal screws on circuit board

Cable gland

M 16 x 1.5, including strain relief, exchangeable,

max. inner diameter 10.4 mm

Permissible air humidity

< 95 % r. H., non-precipitating air

Protection class

III (according to EN 60 730)

Output

4...20 mA

Protection type housing

IP 65 (according to EN 60 529) Housing tested,

TÜV SÜD, Report No.713139052 (Tyr 1)

Sensor protection

sensor sleeve, stainless steel V4A (1.4571), Ø = 6 mm,

nominal length NL = 50 mm (other dimensions optionally available)

cable entry stamped (optionally rolled)

Measuring ranges

multi-range switching with 8 switchable measuring ranges,

see table (other ranges optional)

with manual zero point correction (± 10 K)

Sensor protection

stainless steel, 1.4571, V4A, Ø = 6 mm,

nominal length (NL) = 50 mm

(other dimensions optional)

cable entry stamped (optional rolled)

Cable connection

cable gland, plastic (M 16 x 1.5; with strain relief, exchangeable, max. inner diameter 10.4 mm) or

M12 connector according to DIN EN 61076-2-101 (optional on request)

Housing

plastic, UV-stabilised,

material polyamide, 30 % glass-globe reinforced,

with quick-locking screws

(slotted/ Phillips head - combination),

colour traffic white (similar to RAL 9016),

housing cover for display is transparent !

Housing dimensions

72 x 64 x 43.3 mm (Tyr 1 with Display)

sensor cable

silicone, SiHF, 2 x 0.25 mm², KL = 1.5 m (other lengths and

range limits optional, e.g. PTFE leads up to +250 °C

or glass fibre with steel wire mesh up to +350°C)

Protection type

IP 65

1101-1152-2219-920

16 same category products: