Analogue Coupling Module KBA-1 / KBAi-1

Brand
€36.92
Tax included

• Analogue manual mode

The coupling module can be switched over to manual mode. This allows an analogue signal of 0 - 10 V

or 0 - 20 mA to be generated independently of a

controller.

• AUTO-OFF-ON with feedback

The coupling mode can switch to automatic or

manual mode. In automatic mode the contact with

feedback is closed, therefore a logic 1 results on the

controller. Multiple feedbacks can be connected in

series.

• DIN 45 mm housing

The standardised housing enables the coupling

module to be installed by means of a 45 mm cutout

behind the covering, it only requires a width of 17.5

mm for this.

Quantity
Add to Compare
Add to Wishlist

Imput side

Rated voltage Un A1 - A2 24 V AC/DC

Tolerance -15%; +10%

Current consumption at 24 V AC / 24 V DC 27 mA / 24 mA

Input signal YR 0 - 10 V / 0 - 20 mA

Output side

Output signal Y 0 - 10 V DC / 0 - 20 mA

Output current in manual switch position 1 mA (at 10V)

Output status indicator Green LED (brightness proportional to the output signal)

Switch for feedback

Max. switching capacity 100 mA / 30 V

General data

Relative turn-on-time 100%

Switching AUTO / MAN Short-circuit-proof

Ambient temperature -20°C … +55°C

Storage temperature -30°C … +70°C

Mounting position Any

Fixing DIN rail EN 50022-35

Protection class of front IP 40

Voltage limitation class III

Degree of contamination 2

Connection cross section 2.5 mm2

Weight 52 g

Standards EN 61000-6-3, EN 60730-1

KBA-1 / KBAi-1

1 same category products: